Methods for Cleaning Your Glass Bong

When cannabis is smoked in a glass water pipe known as a bong, the resin from the herb accumulates gradually over time. This creates a residue on the surfaces of the glass. If the gummy substance becomes very thick, the bong will become unusable. Additionally, it discolors the water and dilutes the cannabis’s flavor. This article describes how to maintain clean, effective, and flavorful smoking equipment to optimize the cannabis smoking experience.

Remove the bowl and stem.

The bowl and stem are where the cannabis from a shop that offers weed delivery in Niagara Falls will be placed. This removable portion makes cleaning the bong much simpler. You should avoid getting the bowl wet when pouring water into the bong.

Empty the old water.

As bong water is sticky and resinous, it is advisable not to dump it down the drain. Pour it into a securely sealed trash bag or a sealed container to dispose of it. You may discard bong water outdoors, but you may not water plants. The same pathogens and fungi that can affect humans will likewise harm plants.

Place the bong in a zip-top bag.

A gallon-sized trash bag should be sufficient to contain the mess. If you do not have a bag with a zip-top, you can complete the instructions below in a garbage bag or over the sink. The bong resin may attach to the sides of your sink, so use caution.

Fill the bong with isopropyl alcohol.

Fill the water pipe with alcohol. Use 16 ounces of alcohol, or enough to partially fill the bong. Instead, pour isopropyl into the bong to clean it. Baking soda and vinegar can substitute for isopropyl alcohol.

Fill the bong halfway with salt.

You will learn more here that salt assists in removing resin from the interior of the bong by washing softly. The alcohol does a decent job cleaning the bong, but the salt eliminates the buildup of the bong’s sides. Use a sufficient amount to guarantee that the salt can remove the glue.

Shake the bag.

This can become messy, so close the bag and shake the alcohol and salt mixture inside the bong. If using a percolator bong, ensure that the mixture enters each chamber. To permeate all cracks, you can invert the bong several times.

Allow 30 minutes for it to soak. 

Allow 30 minutes for the alcohol mixture to settle in the bong. This step is not always required, depending on how dirty you let your bong become, but soaking it boosts the cleaning power of the alcohol.

 

Remove the water pipe and dispose of the bag. Here’s why the bag is important: filthy bong water may be sealed in the bag, then discarded. This eliminates the mess caused by resin in the sink.

Rinse the bong with warm water and soap.

Before using the bong, it is best to remove the alcohol and salt, especially because alcohol is combustible. Remove any residual oil from the glass using dish soap and warm water.

 

Soak the bowl and stem in alcohol to clean them.

Scrub any resin that has adhered to the stem with a pipe cleaner. Before loading it with weed from a shop that offers cannabis delivery in Niagara, thoroughly rinse it with hot water and allow it to air dry.

Conclusion

Regularly cleaning your glass pipe or water pipe is mandatory, unlike cleaning your room or doing the dishes. Not only is it awful to smoke from a dirty pipe, but you may also be inhaling leftover tar or altering the flavor of your buds. Therefore, if you want to taste your cannabis and all of its terpenes every time you smoke, rather than stale bong water, you must clean your bong properly.